If the new battery has plastic covers over the terminals, they must first be removed. Be careful that nothing, especially metal, touches the terminals of the battery or the connectors attached to the ends of the black and red wires. Once both of the connectors have been removed, the battery can be taken out of the control box. After the black connector is removed, the red connector can be similarly removed from the battery’s positive terminal. In some cases, the connector will have to be wiggled back and forth to loosen it from the terminal. If the connector does not easily pull away by grasping the insulation on the wire, then insulated pliers may be required. To remove the old battery, pull the black wire and connector from the negative terminal. To remove all doubt about which battery should be used, it is recommended that a licensed technician be called. If the replacement battery does not match the battery inside the box, then a different battery may be required. The battery will usually be sitting on the bottom of the control box. To open the door, it is necessary to remove the screws on the cover or to unlock the door with the key. The battery for ADT alarm systems resides in the control panel. This will allow the job to be completed without accidentally activating the alarm. Any tools used in conjunction with the removal or installation of the battery should be insulated, and both the old and new batteries should be checked for cracks or other anomalies.īefore removing the old battery, it is necessary to call ADT so that an operator can remotely set the system to test mode. Improper use or handling of the battery may cause an acid leak, electrical discharge or explosion resulting in serious injury. Before Replacing the BatteryĪlways handle the batteries with care. Fortunately, these batteries can usually be replaced without having to call a technician. Even if the battery is never used, the charge slowly drains over time, and eventually, it will lose all functionality.

WARNING: Do not disassemble, short circuit, or dispose of in fire.Although ADT security systems run primarily on a home’s AC electricity, they also have a backup DC battery that is designed to provide power in the event of a blackout. Dispose of used batteries according to instructions provided. Connect the power supply to the Touchscreen and plug into a non-switchable 110VAC, 60Hz outlet for 24 hrs to fully charge battery.ĬAUTION: Risk of explosion if the battery is replaced by an incorrect type.

Align the tabs on the battery cover plate and snap into place. Align the contacts on the battery pack over the pins on the touchpad and press down to secure. To replace the battery, place the touchpad face down and pull open the desk stand. If you are looking for a replacement battery for the main ADT Command Control Panel, you can go here. This battery will only work with the ADTommand Secondary Color Touchscreen Keypad. Note: make sure you are ordering the correct battery for your secondary keypad seen below. You can just order the battery here and we will automatically ship it to your home so you can replace it yourself. This battery uses a charge voltage of 3.8V with an energy capacity of 10.64Wh / 2800mAh which will occasionally need to be replaced. The ADT Command Wireless Touchscreen Keypad Replacement Battery works as a backup battery for the ADT Command Secondary Color Touchscreen Keypad. ADT Command Wireless Touchscreen Keypad Replacement Battery

Adt keypad battery replacement